AirsoftGuns s.r.o.
Processor unit, Extreme, JeffTron
MOS FET controlled microprocessor with active brake designed for electric airsoft weapons (AEG) from the JeffTron company. Adds new ways of firing mode, variable rate of fire of weapon, active motor braking and indication of low battery. Extreme variant with a cooler suitable for the strongest springs and the largest load.
Processor unit, Extreme, JeffTron. MOS FET controlled microprocessor with active brake designed for electric airsoft weapons (AEG) from the JeffTron company. Adds new ways of firing mode, variable rate of fire of weapon, active motor braking and indication of low battery. Extreme variant with a cooler suitable for the strongest springs and the largest load.
The mainly parameters:
- Switching the motor by MOS FET use with an active brake
- The fluent change of rate of fire using PWM control
- Allows you to set firing modes, Burst, motor speed, time of delay
- Overview of passing current, voltage and temperature of components
- Indication of low battery for 2S and 3S Li-Po, 3S li-fe, 3S li-on
- Low vibration motor is used for signaling for user |- MOS FET is able to use for currents up to 2.5 times greater than the basic version
Selecting firing modes:
- Safe - Semi - Auto
- Safe - Single - Burst/Auto
- Safe - Semi - Semi
- Safe - Single - Burst
- Safe - Semi - Semi (with delay)
- Safe - Burst - Auto
Specifications:
- Designed for all airsoft electric weapons(AEG) with fitted by spring with maximum toughness of M190
- Wireless board for power paths can be used for wire with max. 1,5q mm cross section and the cross section for signal 0.25q mm
- Designed for all types of co mmonly used batteries up to 12V (Ni-xx 8.4 - 12V Li-Pol 7.4 - 11.1V)
- Cooling system serves to dissipate heat, thereby increasing the capacity MOS FET for switching the motor
- Device size 42x18x15 mm
- Current consumption forces only 4.5 mA in idle mode
- Contactless switching motor
- Devices enhances rate of fire weapon and battery life than the original wiring in weapons
- WARNING: The installation of this equipment is needed expert who must know how to solder and spread AEG gun.
Recommended airsoft accessories, parameters, review and other useful information about the product Processor unit, Extreme, JeffTron can be found in the bookmarks.
The mainly parameters:
- Switching the motor by MOS FET use with an active brake
- The fluent change of rate of fire using PWM control
- Allows you to set firing modes, Burst, motor speed, time of delay
- Overview of passing current, voltage and temperature of components
- Indication of low battery for 2S and 3S Li-Po, 3S li-fe, 3S li-on
- Low vibration motor is used for signaling for user |- MOS FET is able to use for currents up to 2.5 times greater than the basic version
Selecting firing modes:
- Safe - Semi - Auto
- Safe - Single - Burst/Auto
- Safe - Semi - Semi
- Safe - Single - Burst
- Safe - Semi - Semi (with delay)
- Safe - Burst - Auto
Specifications:
- Designed for all airsoft electric weapons(AEG) with fitted by spring with maximum toughness of M190
- Wireless board for power paths can be used for wire with max. 1,5q mm cross section and the cross section for signal 0.25q mm
- Designed for all types of co mmonly used batteries up to 12V (Ni-xx 8.4 - 12V Li-Pol 7.4 - 11.1V)
- Cooling system serves to dissipate heat, thereby increasing the capacity MOS FET for switching the motor
- Device size 42x18x15 mm
- Current consumption forces only 4.5 mA in idle mode
- Contactless switching motor
- Devices enhances rate of fire weapon and battery life than the original wiring in weapons
- WARNING: The installation of this equipment is needed expert who must know how to solder and spread AEG gun.
Recommended airsoft accessories, parameters, review and other useful information about the product Processor unit, Extreme, JeffTron can be found in the bookmarks.
